Wireless Remote Switch DC 8V/12V/24V/48V/72V/86V 30A Relay RF Remote Control 328ft Long Range for Anti-Theft Alarms Security Systems Roller Lind Door

So simple an effective. Works great though the range may be a bit less than advertised.You get a lot for the money.

So, the receiver on the logic board of my chamberlain garage door opener went bad. Since the logic board was too expensive and the wired push button still worked, I used the remote controller, together with a relay and a 9 VDC power supply, to fix it. Very simple and elegant solution. Now I use the remote configured as a momentary switch wired in addition to the wired push button (which still worked). Cheap, simple and elegant solution. Additional components you need to get: a relay and a power adaptor. It works! The photo shows the wiring and placing of the remote receiver with the relay hot glued above.

I bought this remote control as an alternative to replacing the failed circuit board in my GENIE garage door opener. I used an old wall wart transformer to power it (12v), and the output as a momentary switch to trigger the door open/close. It is great - the range is further than my old garage door opener, the programming was very simple, and the little key fobs look nice. I hope the “jelly” surface buttons don’t melt in the summer heat.

The media could not be loaded. I installed this on my kids power wheels jeep, for when they drive off and aren't paying attention or listening. It was a fairly easy install into a relay and then a pwm. You can hear it turning the relay on and off in my video.It works well for short range, but the advertised distance is quite the exaggeration. I think I got it to work for 20, maybe 30ft. I had to chase after my kid at the park to get close enough to kill it, and that was in a flat open field. I will try running a longer wire to see if it improves the range.I know this is a remote module, but I do wish it had a switch on the unit to toggle it ON manually, bypassing the remote, or at least a memory to turn back to the last state after losing power. Each time the battery is disconnected/reconnected, I have to hit ON on the remote. If I have a situation where I don't want/need to use it (e.g. My kid is riding around the fenced in backyard), I don't want to have to turn it on for them each time, just let it work. If you don't have the remote or the battery in it dies, you are out of luck. Outside of a couple caveats, it functions well and is a decent value.

This is easy to install and user-friendly. Great quality

Unfortunately didn’t even work the first time I installed it

I have an older model motion duck decoy that was damaged in the water. Controls completely destroyed. Contacted manufacturer, no luck on replacement parts - told me to buy a new one. Seemed like a waste, so I took it apart and rebuilt/rewired. I added this remote control to the circuit so that I can remotely activate the wing spinning motion from my blind. The unit sits inside the decoy body, I used tape to secure it to the battery holder. The duck runs on a 6vDC lithium battery, was worried that the voltage was out of spec. Tested it today, works great! My distance is less than 30 yards, turns on and off with the remote as expected. Nice to be able to repair the decoy in time for hunting season.

I used this as I didn’t want to drill holes in my dash in my truck. Used it for running the 52” led light bar!